How to Prolong The Life of Your CO2 Laser Cutting Machines?

How to Prolong The Life of Your CO2 Laser Cutting Machines?

During sublimation printing industrial, CO2 laser cutting machines usually be used in cutting fabric and leather. Because of the frequently use, the machine will certainly wear out. In order to save the cost, we must learn to how to maintain our laser cutting machines. Do you know how to prolong the life of laser cutter? Reading the following and I will share you more.

The Steps to Prolong The Life of CO2 Cutting Machine

1. Laser tube mounting fulcrum to be reasonable, the fulcrum of the total length of the laser tube should be a quarter, or laser mode will be worse, some of the work will change to a few points the laser, so that the power supply can not meet the requirements, then changing the tube

2. The cooling system has a connection to the ground. Regularly clean the tank and water, and to ensure that the thermostat temperature is necessary. Otherwise the laser tube susceptible to damage or reduced life.

3. Check water protection. Cooling water should be used cold, clean water and change them regularly. Protection of water resources in the dirt, or cause the laser tube burst or cold head.

4. Check the exhaust fan unit, and regular cleaning duct. Otherwise, a lot of smoke did not break out, heavily polluted fast lens and laser tube, so that all mechanical and electronic components are easily oxidized leading to poor contact.

5. Check the focusing lenses and mirrors. After long-term use, the frame may have a fever, the lens surface discoloration rust; Tuomo cracking belong replacement object, especially a lot of customers with a large air pump and an air compressor, the lens focus on the water quickly, so you must Check a good or bad time to clean and quality lens (laser tube optical) optical system.

6. The machine can not work under too harsh working environment, if the ambient temperature is above 30 degrees, ratio, too much dust, air pollution reduced by 18 degrees, so the machine severely damaged, the failure rate rises; electrical appliances in wet conditions Accessories very easy questions. Thus, in this particular remind customers to improve the working environment and regular maintenance of the machine.

The Steps to Prolong The Life of CO2 Cutting Machine

7. A portion of each contact point of distribution and the entire device is good (fan, water-cooled machines, laser machines, laser power, is an independent computer power).

8. Working current laser tube should be reasonable, rather than long-term work in the light intensity 90-100; rationalization and save laser energy laser; an optical system is properly cleaned, otherwise it will cause premature aging and laser tube rupture, laser working time machine so strong 50-60% should be adjusted according to the material and re adjust the pace of work, this is the best working state of the laser tube.

9. The base plate and the treated material is smooth, otherwise inconsistent in some places the focal length is not cut through, so you must increase the light intensity, the laser tube will cause to rapid aging.

10. The laser power supply was cooled, opened, but in other aspects of the operating current adjustment of the temperature rises above 50% is very high, so that the laser power increased failure rate. Power like some machines can take down the side door, direct consumption of heat emission.

Okay, this is all I tell you the methods of how to protect your CO2 laser cutter. If you have any other needs or questions welcome to contact us at any time. We will provide you the best quality product and service. Hope my article can be useful to you. Thank you for your reading.

Leave a Reply

Your email address will not be published. Required fields are marked *